1、鋼卷吊具在利用階段中，如反映旋鎖轉動不迅敏敏或不專業到位，應看調整調整螺母，再看以內部件： 　　2、棘爪的剪切繃簧不會是影響，如影響，則應更換; 　　3、鏈鏈齒輪變速箱企業都并非產生卡滯，如卡滯，屬平整異常的，則應在鏈鏈齒輪變速箱企業的促銷活動鏈接處加氟平整油(或平整脂)，如屬導向性銷太緊，應非常合適調松螺母。如屬鏈接滑絲、鏈鏈齒輪變速箱管或另外桿件變型，則應校正; 　　4、緩存數據繃簧熱塑量是不只是是過小，若過小，則應大幅度縮短緩存數據繃簧融合的綱絲繩長短。 　　5、運行中應以免鋼卷吊具表示標牌板上的表示標牌表示標牌內墻乳膠漆能爆出。即日起知道，需當即補原表示標牌表示標牌的內墻乳膠漆。 　　6、更多鋼卷吊具上的材料繩，不得令地清潔并涂以均勻油或均勻脂，尤為是材料繩彎折處。   1. During the use of the steel coil spreader, if the twist lock is insensitive or not in place, check and adjust the adjusting nut, and then check the following parts: 2. Is the tension spring of the pawl damaged? If damaged, it should be replaced; 3. Whether the transmission organization is stuck, if it is stuck, it is not smooth, then lubricating oil (or smooth grease) should be added to the joint of the transmission organization. If the guide pin is too tight, loosen the nut appropriately. If the connection is loose, the transmission tube or other rods are deformed, it should be corrected; 4. Is the tension of the buffer spring too small? If it is too small, the length of the wire rope connected by the buffer spring should be shortened. 5. During operation, avoid falling of the indicator paint on the indicator plate of the steel coil spreader. Once found, it is necessary to promptly replace the paint with the original indication mark. 6. Regarding the wire rope on the steel coil spreader, the ground should be cleaned and coated with smooth oil or grease, especially the bend of the wire rope.